Hello,
Thanks for letting me join this forum. I am a member of the 16 ga, forum also as well as the 16 gauge group. I'm here because I am seeking information on reloading my 1923 sxs 20ga. I would like to find a load about 1200FPS and 9000PSI or less. D in AZ suggested that this is the place to get some great information. I would like to load Steel #7..that said I'm open to any suggestions.
Thanks for having me as a New Member.
Doug
Introdution
Moderator: hawglips
-
- Site Admin
- Posts: 318
- Joined: Thu Feb 18, 2016 2:02 pm
- Location: Oldsmar Fl
Re: Introdution
Doug,
Welcome to the board. After you poke around and look at the links up top let us know if you have any questions. I have been trying to find that perfect 20gq round and im still looking/testing.
Welcome to the board. After you poke around and look at the links up top let us know if you have any questions. I have been trying to find that perfect 20gq round and im still looking/testing.
Roll with it. If you stay above 55 the wheel wont fall off.
-
- Site Admin
- Posts: 318
- Joined: Thu Feb 18, 2016 2:02 pm
- Location: Oldsmar Fl
Re: Introdution
2289dcd wrote:Hello,
Thanks for letting me join this forum. I am a member of the 16 ga, forum also as well as the 16 gauge group. I'm here because I am seeking information on reloading my 1923 sxs 20ga. I would like to find a load about 1200FPS and 9000PSI or less. D in AZ suggested that this is the place to get some great information. I would like to load Steel #7..that said I'm open to any suggestions.
Thanks for having me as a New Member.
Doug
Doug,
Thinking about this since your reloading #7 steel have you looked at any of the published loads in manual? I'm sure we can get you some good info on steel. Let me ask a few questions :
- What are the loads going to be used for at 1200fps I would assume clays?
- What will you be reloading with (hand loader or mechanical)?
- What hulls do you prefer or be using?
- Do you have a preferred wad or powder?
Thanks,
FishH2o
Roll with it. If you stay above 55 the wheel wont fall off.
Who is online
Users browsing this forum: No registered users and 0 guests